I've seen your excellent Yup MVT7000 write ups and was always fascinated with what was inside them.
I purchased a spare memory battery for mine as a result of reading your posts but was quite afraid to start pulling her apart to just do it as a routine maintenance thing.
She's been on the shelf for a few weeks now as I'd bought some Signal R series old receivers recently and today I got her out put in some new batteries and fired her up.
I was greeted with the usual white noise but when I looked at the screen it was blank.
As I know the routine for airband frequency programming I entered my local tower.
She works....but no display.
Obviously the battery needs now to be changed as it's lost all my frequencies but is the blank screen related to this too ?
I love this radio and would like to get it back to normal if possible.
It's in excellent and clean condition and not been abused or dropped.
Any advice most welcome if you pick this post up
Many thanks
Andrew
